How to Fix Common Problems on Entry Doors

The main door plays a very vital role in securing your home. It also adds to the external look of your house. However, the main entrance of a home is exposed to all the elements. It has to bear the brunt of tough weather all seasons. Because of this, the main entrance is very prone to damage. Besides, there is the normal wear and tear that each entrance goes through over time.

Therefore, it is very important to understand a few repair techniques that you can use to fix your main entrance.

Repairing the Entry Door

The reason why an entry door will stick is because it’s larger in size than the entryway. In order to fix this, you will need to adjust the door’s size. Try and also remove any dirt build-up or debris along the hinges and the door edges. Sometimes loose hinges may cause the entrance to stick. Tighten the hinges too and see if the problem is fixed.

Repairing Dents

Dents are also very common in main doors. The severity of dents will depend on the type of door you have. For example, if you have a steel entrance window installation, dents can be repaired using auto filler. Sand the damaged area until you see the steel. Apply the auto filler in layers until the door is smooth.

Squeaky Hinges

The squeaking sound that’s heard every time you open or close the door can be very annoying. However, it’s an indication that the hinges are not working properly. The first thing you should do is to lubricate the hinges and see if this solves the issue. Try to clean up the hinges too.

Stopping Air Leaks

Sealing your main window repair is very important, especially to enhance energy efficiency at home. But how do you know your door needs to be sealed. If a cold draft is forming on your main entrance during the cold winter months, then sealing is needed. You can do this by using various techniques. First of all, check out the caulk to see if there are gaps in between. You can also install a weatherboard. The weatherboard will seal off the entrance’s bottom very effectively.

How to Install a Weatherboard

Installing a weatherboard on your main entrance is easy. The first step is to measure the distance between the frames and the stiles. Cut the weatherboard based on these measurements. Proceed and pre-drill some holes in front of the board.

On the board’s underside, apply wood preservative. Wait until the preservative is dry before you start applying wood adhesive on the back edges. Finally, screw the board in place. Open and close the door to ensure the board is properly installed.

Dealing with damages and repairs on entrance window cleaning is not difficult. The simple repair tips above will help you fix any problem. They are all basic DIY solutions that will save you a lot of time and money.