As water-heaters age, the interior tanks that hold water can weaken from corrosion and rust. This causes the sometimes dumping the water contained in the tank to leak, as well as tanks. Many municipalities require that homeowners install a hot-water heater pan beneath the the hot-water tank. So the water that leaks to the pan may be safely emptied the pan keeps the water from spilling onto the ground, but includes a drain line. When installing the drain pan and drain line you need to follow local building codes.
Lay a course for the drain line out. Most municipalities require that water empties right into a floor drain or outside. When determining where to empty any water that drains from the tank follow local building codes. Empty the water, should you not have a floor drain. In the event the hot-water tank is is at 6″ of the drain, you should use a rubber hose or a PVC conduit for the drain line. When it’s further than 6″, make use of a rubber hose. A PVC conduit that extends out too much in the hot-water tank be at threat from being inadvertently damaged, in addition to can present a hazard.
Drill a hole in the drain pan in the event the producer didn’t pre-drill a hole. Set the base of the hole 1/2-inch from the bottom of the pan. Follow the narrower (threaded aspect) of the PVC fitting on the face of the drain pan to indicate the hole you should cut. The fittings are often contained with all the drain pan, but in the event that you must buy one individually, get one which is at least 3/4-inch. Anything smaller than that will not let the pan to empty rapidly enough.
Add the side of the fitting to the hole and fasten it with all the nut. While you tighten the nut using a set of channel-lock pliers, hold the fitting.
Use a bead of apparent silicone adhesive across the joint where the fitting makes connection with the drain pan to assist seal the joint. Put on the adhesive to either side of the drain pan.
Cut an item of rubber hose or PVC conduit to fit the space involving the drain pan as well as the positioning where you are emptying the water (ground drain or sump pit).
Slide one end-of the rubber hose within the fitting on the not in the pan. Fix the hose having a hose clamp. Put another end of the hose within sump pit or the drain line. Utilize PVC primer to the surfaces of the fitting as well as the pipe which is in con Tact with each other in the event you are utilizing PVC conduit. Let the primer to dry, then use PVC cement. Fit fitting and the conduit together and maintain them closely for 30 seconds as the cement treatments. Utilize a torpedo le Vel to make sure that the conduit is le Vel or slopes down a way from your drain pan, perhaps not toward the drain pan.
Put the drain pan in place in order for the hot-water tank might be put inside it.